This Guide shows you how to set up your TriRig Omni with the TriRig Alpha One or Alpha X aerobars. This Guide can help you replicate your current bike position, or set up your bike based on numbers from a bike fitter. The Fit Chart below shows the actual X/Y coordinates of your arm pads measured from the bottom bracket. This coordinate is the most important number that bike fitters use to determine your position on a triathlon bike. Be aware that some fitters use a coordinate to the top/back of the pad, rather than the top/center. In that case, you can subtract 44mm from all of the reach numbers in the Fit Chart, which yields the back of pad number. The steps below provide an easy-to-follow system for making sure you have the perfect fit with your Omni.

Step 1: Determine your current fit numbers Show instructions »

Measuring Stack/Reach

What we want is the X/Y coordinate to the top/center of your aerobar pads, measured from the bottom bracket. Most bike fitters can provide this number to you when performing a bike fit (although some provide it to the top/back of the pads rather than top/center). If you already know these numbers, you can skip this step. Otherwise, follow the steps below to determine these numbers for your current bike setup:

1. Place your bicycle up against the corner of a room, with the back tire abutting the wall.
2. Next, measure the vertical distance from the floor to the center of the bottom bracket. We'll call this measurement Floor Offset (FO).
3. Measure the horizontal distance from the wall to the center of the bottom bracket, we'll call this measurement Wall Offset (WO).
4. Measure the vertical distance from the floor to the top of your aerobar pads. This measurement will be Pads-To-Floor (PTF).
5. Measure the horizontal distance from the wall to the center of your aerobar pads. This will be called Pads-To-Wall (PTW).
6. Subtract Floor Offset from Pads-To-Floor (PTF minus FO). This is your Pad Stack.
7. Subtract Wall Offset from Pads-To-Wall (PTW minus WO). This is your Pad Reach.

Step 2: Review Frame Geometry

Step 3: Select Size, then find your position on the chart Show instructions »