BLACK FRIDAY SALE! Get 15% Storewide NOW! (excl. Omega One, Styx, ends Dec 4th)
installation

Omega One Installation Guide

The Omega One installs much like a standard single-post brake, and is the easiest aero brake on the market to set up.

  1. Begin by removing the wheel - it is easier to install the Omega One without a wheel in place. We will bring it back for pad adjustment later.
  2. If your bike uses a direct-mount standard, either Shimano Direct-Mount or TRP U-Mount, begin by removing any pre-installed canti studs, to expose the direct mount bosses. These will be either M6 threaded holes (for Shimano Direct Mount) or M8 holes (for TRP U-Mount). The Omega One universal Direct-Mount Adapter is compatible with both. If your bike has both direct-mount AND traditional single-bolt attachment options, always use the single-bolt attachment.
  3. Next, remove the Omega One Front Plate and install the brake with one of the included M6 Thru Bolts.
    • If your bike has a standard single-post brake mount, thread the M6 Thru-Bolt through the brake, then one or more Serrated Washers positioned on the back of the brake. Pinch in place and slide the whole onto the fork. Hold it in place with a 4mm hex wrench, while you tighten the Recessed Nut with a 5mm wrench. Tighten to a torque of 10-12 Nm, or whatever is recommended by your fork manufacturer.
    • If you are using the Direct-Mount Adapter, use the shortest thru bolt, which is 14mm long - you do not need any additional Serrated Washers or Recessed Nut, as these are integrated into the Direct Mount Adapter itself. Tighten using a 4mm hex wrench to a torque of 7-8 Nm.
  4. Next, run brake cable housing up to the Omega One cable hanger, and run a brake cable through the brake levers on your handlebars, and through the Omega One Wedge. Pull the cable taut using a pair of pliers, and ensure there is no slack in the system by actuating the handlebar brake lever while also keeping tension on the cable. (If you are using an upstream cable stop, such as the integrated stop on our Alpha One aerobars, run your housing to that stop and simply run bare cable through the Omega One Cable Hanger).
  5. Keeping the cable taut with the pliers, tighten the center pinch bolt on the Wedge, to a torque of 4 Nm.
  6. Trim the cable, leaving approximately 1cm of cable below the Wedge. You may install a cable tip at this time if you wish. However, ensure that there is at least 3mm between the bottom of the cable tip and the bottom of the Omega One Back Plate arc, to ensure that the cable tip will not contact the Front Plate when it is replaced. Any cable interference will compromise the brake's ability to return properly.
  7. Replace the Omega One Front Plate, and reinstall the wheel.
  8. The Omega One comes with Kool Stop Salmon pads, the industry's best pad for use on alloy rims in any riding conditions. If you are using carbon rims, use the brake pad supplied by that rim manufacturer. Or if none is supplied, we recommend the SwissStop Black Prince pad, available at your local bike shop. Adjust the pad height and pad angle, ensuring it properly contacts the center of your rim's brake track. Using the M4 set screws on the sides of the Omega One Levers, adjust the pad stance width so that the pads are 1-2mm away from the rim on either side.
  9. You're ready to ride!